Cabinet Repair & Re-Installation

Cabinets and millwork take a beating over time. Doors sag, drawers stop tracking, hinges loosen, trim pulls away from the wall, and finishes start to wear.

W2W's repair and re-installation service brings existing cabinetry and millwork back to working condition. Whether you have one drawer that won't close or a whole kitchen that's slowly drifted out of alignment, we re-set, re-shim, and re-secure each piece so it works the way it should.

Licensed C-6 contractor — CSLB Lic. #1087162.

What we handle

• Doors and drawers that sag, rub, or won't close properly
• Loose, broken, or worn-out hinges and slides
• Cabinets that have come out of plumb or level over time
• Loose, damaged, or pulled-away crown molding, baseboards, and trim
• Re-installing cabinets that were removed for a remodel, paint job, or floor work
• Touch-up and finish repair on existing millwork

How we work

We start with a quick walk-through to understand what's going on with your cabinets or millwork. From there, we give you an honest assessment: what can be re-installed and adjusted, what may need replacement parts (sourced through your cabinet maker or supplier), and what's outside the scope of an install-only repair.

If your project is too far gone for repair, we'll tell you straight up — and if needed, refer you to a trusted cabinet maker or designer who can build replacement pieces, then we come in and install them.